| |
|
|
|
| |
 |
| |
WATERGYM BELTS
WEIGHTS & DVD'S ARE
MADE IN U.S.A.
Order ONLINE
or call toll free:
1- 888 - WATERGYM
(888-928-3749)
In CA (415) 435-1079
San Jose Magazine's
2007 Reader's
Choice Award
Voted WaterGym
"Best Choice for
AQUATIC FITNESS"
and other press
|
| |
|
|
| |
|
|
|
|
| |
|
|
| |
 |
| WATERGYM WATER AEROBICS FLOTATION BELT |
|
HOW TO CARE FOR YOUR NEW
WATERGYM WATER FLOTATION BELT
  
1. How do I care for my new WaterGym® Belt?
Your new belt is molded out of a high quality, super-soft foam, which is one of the reasons our belt is one of the most comfortable flotation belts on the market today. The inherent nature of foam is that it can be damaged without proper care. So be sure to handle your belt with care and follow these few simple instructions to prolong the life of your belt…
- Rinse with clean, fresh water after each use. Hang flat to dry.
- Do not fold or squish your belt into lockers or tight areas, or stack your belt
on top of one another, which can crease or damage the foam.
- Store belts indoors and away from extreme hot or cold weather conditions.
- Be gentle when tightening your belt. Do not pull and tug on the black elastic webbing so hard that it stresses the foam. It is best to take off your belt, make your sizing adjustment, then put your belt back on. This is especially important when there are multiple users of a single belt (such as in a swim facility). Only do this while out of the water!
- Be careful not to puncture or tear the foam. Check frequently to make sure.
2. I accidently punctured/tore my new belt. What should I do?
No worries! The great thing about our belt is that our foam can usually be repaired with common super-glue! Here’s how…
- Rinse your belt with fresh water and then let your belt dry out completely for at least a day or two. Make sure all of the moisture is out of your belt before proceeding…
- Apply a generous amount of "super glue" (also known as "crazy glue") to the entire surface area that has separated. Make sure to apply to both surface halves, coating the entire center area all the way out to the edges of the foam.
- Firmly press the two sides of foam together and hold for about 20-30 seconds. Be careful not to get any super-glue on your fingers or they will stick to the belt!
- Test the seal of the foam by gently pulling to see if it adhered. If not, add more super glue and repeat.
- Let the belt dry completely for one or two days before using. Your belt is repaired!
|
|
|
 |
WATER AEROBICS EXERCISE WORKOUTS FOR WATER FITNESS ENTHUSIASTS!
|
|
|
|
|
|
